Knowledge
Home > Knowledge > Content
Daily use and maintenance of hydraulic imitation stone brick press
- Dec 21, 2018 -

As an operator of a hydraulic imitation stone brick press, it must be trained to master the equipment performance and operating technology before it can work independently. Before the operation, the various impurities on the mold should be cleaned and any dirt on the hydraulic rod of the stone-like brick should be wiped off. The installation mold of the hydraulic imitation stone brick press must be carried out under the condition of power failure. It is forbidden to collide the start button, handle and foot on the foot switch; install the upper and lower molds to center, adjust the mold gap, do not allow the single side to deviate from the center, confirm After fixing, the mold is tested again.

 

Before the work of the hydraulic imitation stone brick press, the equipment is first idling for 5 minutes. At the same time, check whether the oil level of the fuel tank is sufficient, whether the sound of the oil pump is normal, whether the hydraulic unit and the pipeline, joints and pistons are leaking. Start the equipment pressure test, check whether the pressure reaches the working pressure, whether the equipment action is normal and reliable, and whether there is leakage. Adjust the working pressure, but should not exceed 90% of the rated pressure of the equipment, test a piece of work, and then produce after passing the test.

 

For different hydraulic imitation stone brick press profiles and workpieces, press and adjust the working pressure and pressure, pressure keeping times and time of the press at any time, and ensure that the mold and workpiece are not damaged. When sliding the body plate down and down, it is strictly forbidden to extend the hand and the head into the working part of the pressure plate and the mold. Do not smoke, weld, or ignite around the hydraulic imitation stone brick press. Do not store flammable or explosive materials. Take fire prevention measures.

 

After the work of the hydraulic imitation stone brick press is completed, the power supply should be cut off, the hydraulic rod of the press should be wiped clean, the lubricating oil should be added, the mold and the workpiece should be cleaned and placed neatly, and the next operation should be prepared.